Greenhouse cultivator sprayer operating instructions
Silica Gel,White Silica Gel,Blue Silica Gel Medicine,Health Food Co., Ltd. , http://www.cn-medicines.com
December 16 01:05:58, 2018
1, before starting power, first turn off the water outlet switch, loosen the regulator screw, and pull the pressure regulator handle to the top; 2, start the power driven sprayer, maintain the appropriate speed, and press the pressure regulator handle to the bottom, adjust Adjust the pressure adjustment screw; 3, open the water switch to start spraying; 4, after the spray is completed, the nut will be loosened, start with clear water to clear the residual liquid inside the sprayer; 5, always keep the parts clean and dry; Note] The sprayer should be replaced with oil during the first 10 hours and 50 hours of use, and should be changed every 70 hours after use. The oil specification is No. 68 cleaner oil, and the oil level should be maintained at two-thirds of the oil level. Always fill with butter and rotate the buttercup 2 or 3 turns every 2 hours of use. Fault Diagnosis: 1. Unable to supply water and unstable pressure: Check whether the water-absorbing plastic tube is leaking or obstructed. Open the water outlet switch to remove excess air. Remove the inlet chamber and the outlet chamber to check whether the valve is obstructed or damaged. 2. Insufficient pressure: Check whether the pressure is adjusted properly. Check whether the flat key in the drive chain box is damaged. Check if the spray pipe and connector are leaked or damaged. 3, cylinder leakage: remove the dust cover and tighten the adjustment ring; if still invalid, replace the cylinder's V-type tight.