How to operate stainless steel distilled water correctly
Home Safe,Home Digital Safe,Electronic Digital Secret Safe,Mini Safe Digital Safe Lock Ningbo Reliance Security Technology CO.,Ltd , https://www.reliancesafes.com
2. Open the water source valve, so that the tap water enters the condenser from the inlet control valve, and then flows into the funnel from the return pipe and then injects into the evaporation pot. Until the water level rises to the center of the glass water level window, the water source valve can be temporarily closed when the water level discharge pipe flows out and its water level stops rising.
3. Turn on the power, wait until the water in the pot has boiled, and then turn on the water source valve. However, it should be noted that the water flow should not be too large or too small. The water source valve should be gradually opened from small to large, and the water output of the distilled water should be adjusted to a large amount. The temperature of the distilled water is about 40 °C.
4. Distilled water effluent should not be too long, and should not be inserted into the distilled water container. The skin should be cleaned and re-washed with distilled water before use, and should be kept open to prevent slumbering steam and cause water leakage.
5. The outer wall of the condenser has a hot hand feeling, which is normal, otherwise no distilled water will flow out.
Maintenance 1. The newly purchased distiller should be cleaned first and then evaporated for more than eight hours to clean the interior. It is then officially used to ensure that the water quality meets the requirements (cleaning can be carried out according to 2).
2. The electrical part should be checked regularly and reliably grounded.
3. The heating element of the distilled water is an immersed electric heating tube. Its structure is made of nickel-chromium alloy as the heating main body, buried in the center of the copper tube, and surrounded by magnesium oxide as the insulation. Therefore, once the water is cut off, the heat generated cannot be absorbed by the water, which will cause the copper tube sheath to burst and burn. Therefore it must be submerged in water for use.
4. If the user replaces the electric heating tube by maintenance, the gasket at the joint must be well-lined to ensure no water leakage. Otherwise, the head of the electric heating tube will break down the insulation when it is energized due to the adhesion of water droplets. The nuts should be tightened at the joints of the ends to avoid sparks after powering and burn the head of the electric heating tube.
5. The impurities in the water source will be left behind by evaporation. Especially when the tap water is poor in water quality and has not been treated, after evaporation, the deposit will have precipitates [scale], which will condense on the barrel wall, the surface of the electric heating tube and the condenser casing. The inner wall, the return pipe, etc., accumulate over time, not only hinder the smooth flow of the waterway, but also affect the condensation effect, so as to reduce the amount of water produced; for the electric heating pipe, it will also accumulate its heat and shorten its service life. Therefore, the scales in the above places should be removed frequently. The cleaning method can be used to wash the surface with a brush, but depending on the combination of dirt, use a weak acid or weak alkali solution for cleaning. Please be careful when cleaning: Do not use excessive force to damage the parts.
6. Wash the inside once every day before use, and drain the water, replace the fresh water, so as to avoid the scale caused by the water quality, affecting the use effect.
7. The distiller must be operated by a dedicated person and must be clearly explained when the new operator is replaced.