Corncob raw material cultivation mushroom new technology

At present, the price of cotton husk continues to rise. Many corncobs are wasted in rural areas. Researchers at the Jiangsu Coastal Edible Fungi Research Institute have used corncobs to produce 100-150 kilograms of fresh oyster mushrooms per 100 kilograms of corn cobs for many years.

Bioconversion rate is more than 150%. It is best to use corncobs that are free of mildew in the year, exposed to sunlight for 2-3 days, and crushed into corn kernels without sieving.
Formula: (1) 950 pounds of corn cob, 20 pounds of lime, 10 pounds of gypsum, 10 pounds of calcium superphosphate, 3 pounds of urea, 3 bags of strong mushrooms, and 1 to 1.5 pounds of mold-promoting spirit. (2) 950 pounds of corn cob and 1 bag of special fertilizer for oyster mushroom

(3 pounds), 150 grams of king mushroom turn king, mushroom 3 bags, lime 20 pounds, Gram-producing spirit 1-1.5 pounds. Preparation method: firstly mix the lime in the material and dissolve the rest in water, then stir in the material, the water ratio is 1:1.2.

After the feed water is evenly mixed, it will be stuffy and stuffy for 12 hours or fermented. Spread the plastic film on the ground and pile it into 1.5m wide, 1m high, and unlimited length piles. Play a few holes through the hole from the top of the stack, then cover with a plastic film or a straw stack.

After one-day fermentation, the temperature of the reactor is measured. If the temperature is above 60°C, turn it on for 6 hours. Turn the material inside out. Turn the material inside out, and then stack it. Ferment it to 60°C and keep it for 12-24 hours. Fermentation is completed.
Loading and inoculation. When the material temperature drops below 30°C, the bag can be bagged, and 2245 cm polyethylene tube bag is used to inoculate according to the three-layer material two-layer inoculation method, that is, one layer of material at both ends (about 2 cm at each end). The header is

Appropriate, each layer of bacteria), sowing rate is 15% of the weight of the material, then take the kind of material bag Zhakou, and then play 3-4 ventilation eyes at both ends (to make mushrooms).
Hyphae cultivation. Two days after sowing, the temperature of the material began to rise. Attention should be paid to changes in the temperature of the material every day. After three to five days, the reactor should be turned one at a time. After another eight to ten days, the reactor should be turned again to prevent the material temperature from rising above 35°C. When the material temperature rises to 32°C,

When the doors and windows are opened, the water is sprayed on the floor to reduce the accumulation of layers, and the bacteria bags are scattered to disperse the heat in the bags quickly to reduce the temperature of the material. The temperature of the bag material is preferably controlled at about 25° C., and the bag is rotated for about 10 days. 180 degrees so that the bottom product

The water infiltrates, in order to spread the bacteria evenly, and then it is bagged once more in 20 days. The bacteria bags that grow the mycelia are put together, and the poor ones are put together. The polluted ones are picked out and the pollution is light. Open in the shade for a few days or use lime

Covered with powder, the pollution moved to a distant place. The relative humidity of the indoor air is maintained at about 65%. Generally, after 25 days, the mycelium can be filled with bacterial bags.

Mushroom management. When the material surface is covered with white hyphae, the bacteria bags can be ventilated. The room temperature is maintained at 14-18°C and the relative air humidity is controlled at 85%-90%. Do not spray water during the bud period, when the young mushrooms should be a small amount of water, grow to

When the size of faba bean is large, the number of water sprays should be increased, and the air humidity should be kept at 90%, and harvested at 5-25 days at 10-25°C. After the first mushroom is harvested, keep the indoor air a little drier, promote mycelium growth and accumulation of nutrients, and enhance ventilation

Transmit light, normal management of the second mushroom after its formation. After harvesting 2-3 oyster mushrooms, nutrient water such as Pleurotus ulmoides, edible mushroom increasing production factor, triacontanol oligo tide, diammonium or potassium dihydrogen phosphate may be injected into the container.

0.8-1 kg of water is appropriate). The temperature during the entire mushroom growth period is controlled at 10-25°C and the humidity is 80%-95%.
Harvested. Pleurotus ostreatus grows from 28 days to 35 days. When the cap is mature, the fruit body is the heaviest and the yield is the highest. When harvesting, hold the mushroom handle and rotate it out. Do not hard-draw so as to avoid damage to the material surface and affect the mushrooming. whole

The growth cycle can take 5-6 mushroom.

Pest Control. If insect pests occur, spray 1000-1500 times against the fungus, and use Wan Xiaoling spray to prevent the occurrence of bacterial yellow mushrooms.

Destoner Machine is used to remove sand, stones, metals from good grain , seed, beans. It is also called Dry Stoner, Stone Removing Machine.

Its working principle is based on gravity weight, to remove heavier impurities from good materials.

The working process is : when seed flow into vibration deck/sieve, with the combined work of vibration and air blowing, the heavier materials and lighter materials will separate in different layers and discharge from different outlet.

We have Air Blowing Type Destoner and Air Suction type Destoner, which will be used for different usage.

The Air Blowing type is 5XQS series destoner, it is a universal Destoner Machine, which can be used for wide range of seed, grain and beans, it has wide processing table with stronger air volume, better for processing all kinds of beans and materials who has lot of stones.

The Air Suction type we have TQSF series destoner and QSX-85 Destoner. They are often used for small granule materials, such as wheat, maize, cumin, paddy etc. their air volume is small, so when processing beans, results not much good.

Our Destoner Machine can be used for all kinds of seed, grain, beans, such as wheat, maize, rice, paddy, sesame, red beans, chickpea beans, soybeans, sunflower seed etc.

We also provide extra table or different sieves to process different materials.

FAQ:

1.       How about payment terms?

Usually is 30%TT in advance, balance 70%TT before shipment. We also accept L/C at sight, Paypal, West Union, Money Gram etc.

2.       How long is the delivery time?

15 days after payment

3.       How about packaging?

We will pack machine into plywood box if ship by LCL. If ship by FCL, we will coat machine with plastic film and fixed well by belt fastener, strong iron wire and steel wedge etc.

4.       Is there any warranty?

Warranty is 1 year.

5.       Installation and commission?

We can send engineer to help installation and commissioning, but you should pay for visa, air tickets, salary and arrange food and hotel when our engineer in your country.

6.       Do you have some videos that will help us on assemble or run the machines?

Yes, we have videos on how to assemble and use our machines, will send you a CD when ship the machine to you.

Destoner Machine

Destoner Machine,Rice Seed Destoner,Wheat Destoner,Stone Removing Machine

SHIJIAZHUANG SYNMEC INTERNATIONAL TRADING LIMITED , https://www.seedgraincleaner.com